Versatility – LEDs perform in all environments, including those that were particularly problematic for CFLs –  cold climates and frequent power cycling.

Recyclability – Since LEDs do not contain hazardous materials they are significantly easier to recycle than CFLs.

Longevity – LEDs last about 50,000 hours, more than 8 times as long as CFLs.

Safety – LEDs are far more break resistant than CFLs and when they do break you don’t have to worry about human or environmental contamination because LEDs do not contain hazardous materials.

All bulbs are sold exclusively through Pharox-Led.com

1. Savings

A properly programmed thermostat you can save more than hundreds of dollars (up to 10% of your heating bill) every year in energy costs.

2. For the Unprogrammed

Turning your thermostat up to 90 degrees doesn’t heat your house any faster.

3. Intro to Thermodynamics

The lower the temperature in your house, the slower your house gets colder. So the longer your house remains at a colder temperature, the less energy your house uses, and the more money you save.

Learn how to program your thermostat at EnergyStar and Energy Savers

And for those of you who want your thermostat to program itself – check out the Nest.

The Energy Works program utilizes BPI certified private energy auditors and approved contractors and provides their own measurement and verification system to apply rebates to completed home improvements.

Fill out the contact form to speak with an Energy Works energy auditor, learn more about programs and schedule your  audit-

*$150 base price applies to homes up to 2500 sqft. Plus $50 for every additional 500 sqft and $100 for additional heating/cooling zones.

A blower door test is part of PPL and First Energy home energy efficiency energy audit programs – so what can you do to prepare?

• Shut windows and open interior doors
• Turn down thermostats
• Cover ashes in wood stoves and fireplaces with damp newspapers
• Shut fireplace dampers, fireplace doors, and wood stove air intakes.

-          19139  -          19023
-          19143  -          19024
-          19104  -          19032
-          19131  -          19036
-          19142  -          19050
-          19153  -          19074
-          19145  -          19076
-          19146  -          19078
-          19079

Insulation comes in a variety of shapes and sizes, but all of it will be rated on its thermal resistance (R-value).  The higher the R-value the greater the insulation effectiveness.  You can install some forms of insulation yourself while others requires a professional contractor.

Types of Insulation
Blankets (batts or rolls) – Made of mineral fiber this form of insulation can be installed by the homeowner or a professional.  Cut the batts down to size to fit them into areas.

Blown-in loose fill –  Typically installed by a professional, this form of insulation is ideal for wall cavities and unfinished attic floors.

Spray Foam – In the cavities of a new home a professional can apply cellulose and fiberglass fibers in the form of a foam.

Foam Insulation – Applied by a professional using special equipment to meter, mix, and spray the foam into place. Polyisocyanurate and polyurethane foam insulation is produced in two forms: open-cell and closed-cell. Open-celled foam allows water vapor to move through the material more easily than closed-cell foam, but usually has a lower R-value for a given thickness compared to closed-cell foams. So, some closed-cell foams are able to provide a greater R-value where space is limited.

Rigid Insulation – Made from fibrous materials or plastic foams and produced in board-like forms and molded pipe coverings. These provide full coverage with few heat loss paths and are often able to provide a greater R-value where space is limited.  Rigid insulation is often used for foundations and as an insulative wall sheathing.

Penn Power, Penelec, and Met-Ed are all currently offering rebates for insulation.